Welcome
About VX CAD/CAM
Installation Guide
CAD Reference
    Title Page
    Forward
    Conventions
    Section 1 - The Basics
    Section 2 - Part Modeling
       Chapter 6 - The Part Level
       Chapter 7 - Part Design
       Chapter 8 - Wireframe Design
          Fillet 2 Curves
          Fillet a Chain of Curves
          Chamfer a Chain of Curves
          Named Section
          Dynamic Sectioning
          Part Annotations
          Rectangle (3D)
          Ellipse (3D)
          Points
          Lines
          Arcs
             Start, End, Radius
             Center, Start, End
             Start, End, Through
             Concentric
          Circles
          Curves
       Chapter 9 - Part Editing
       Chapter 10 - Assembly Design
       Chapter 11 - FABDesign (Sheet Metal)
       Chapter 12 - Mold & Die Design
       Chapter 13 - Advanced Rendering
       Chapter 14 - Inquiring Part Data
       Chapter 15 - Part Tools
    Section 3 - The Sketcher
    Section 4 - Detail Drawing
    Section 5 - Appendix
CAM Reference
Advanced Tools
Release Notes
Configure VX
Customize VX
Applying VX CAD
Applying VX CAM
CAD Tips & Techniques
CAM Tips & Techniques
FAQs