Hole
Table (2D) 
Insert (Drawing Sheet Level)
Use this command to create a hole table and
place it in the Table Manager. The table is based on a layout view
that contains holes that you want to tabulate. A base point determines
where the hole centers are dimensioned from.
The Optional Inputs provide controls for columns, center measure method, starting hole number, etc. Refer to the Optional Inputs section below. Tables can be blanked and unblanked if desired. Once the hole table is created, use the Table Manager to insert it onto the drawing sheet.
This command comes in handy when you have many holes of different sizes and locations that makes standard dimensioning cumbersome. This command creates callouts similar to Label Dimension attached to each hole. After the command is complete, you can double-click on the callouts to relocate them as desired.
Column Editor - The list on the left shows the column headings that will be included in the hole table. Place a check in the box next to a heading to add it to the list. Use the Delete, Move Up and Move Down buttons to act upon the selected column header in the list.
Balloon/Note - Use this option to specify the format for the hole label. Balloon uses circles and ID numbers to identity the hole locations. Note only shows the ID numbers similar to a Label Dimension.
Start label - You can specify the starting label number for the first hole in the table. By default, the next available hole label number is specified.
Currently, this command will not regenerate if the 3D hole feature locations change and the view is regenerated. You will have to delete and recreate the table. However, you can change hole depths.
