CAM Plan Settings

Edit (CAM Level)

Use this form to set a variety of CAM Plan settings.

Units

Select the CAM units of measurements from the list (mic, mm, cm, m, mil, in, ft or yd). The default unit is highlighted.

Tolerance

This setting refers to the default CAM geometry tolerance measured in the default units. The geometry tolerance is feature dependent. Every new feature is assigned a geometry tolerance as defined in this form at the time the feature is created.

You can adjust the geometry tolerance for individual features using the Set Feature Tolerance command.  Use Caution when Modifying the Geometry Tolerance (see CAD Tips & Techniques).

Alternate display of free edges

This sets the free edge display mode. If checked, all free edges (openings in a shape) larger than the geometry tolerance are automatically displayed with attributes from the Line Attributes Form.