Check Tool Path Regen Status
Edit 
CAM Regen Status (CAM Level)
Use this command to check each tool path against the Tool,
Setup, CAM Features and Components and display the results. 
The CAM Components are also checked against the Part or Sketch
they reference. If there have been changes since each tool path was last
calculated a message like the following will be presented for each.
CAM Object Status Information Form
If any relevant objects have been changed more recently than
the Tool Path's time stamp, a window
will be presented with a prompt like the following:
Tool Path Status Alert Notice
Yes - Recalculate the out of date tool path.
Yes All - Recalculate all out of date tool paths. You will not be prompted again.
No - Move on and check the remaining tool paths in the Plan.
Cancel - Halt the checking process. No more tool paths will be checked for being out of date.
Although the checking can be performed on any of these CAM Objects in any order, it is important to bring things up to date in the right order. That is, it will do little good to recalculate the tool paths if the CAM Features they depend on are out of date. Bring things up to date in the order that appear in the CAM Plan Manager.
