Fillet 2 Curves (3D/2D)
Insert
Wireframe (Part Level)
Insert Geometry > Fillets (Sketch/Sheet
Level)
Use this command to create
a fillet between two curves. The required inputs include the curves and
the desired radius.
Optional inputs include tangent and curvature controls, the trim and extension methods. See Optional Inputs below.
Use designer arcs
Check this box to use a designer arc instead of a traditional circular arc. A designer arc is a NURBS curve that matches the tangency of the arc but has zero curvature at the end points. See Applying VX CAD - Using Designer Arcs for more information.
Extension
Use this option to control the path of the extended curves.
Linear - The extension follows a linear
path.
Arc - The extension follows an arc path in the direction of curvature.
Reflect - The extension follows a reflective path opposite the direction of curvature.
Trim
Specify if automatic trimming should be perform on the curves. Select from the following:
Trim Both
No Trim
Trim First
Trim Second
