Polygons (2D)
Insert 
Geometry Line
(Sketch/Sheet Level)
Use these commands to create 2D polygons in
a sketch or on a drawing sheet. They can be inscribed or circumscribed
about a radius or by specifying an edge length. Any number of sides can
be specified and snap angles are supported.
Polygon
(2D), Inscribed Radius Method
The Inscribed Radius Method creates a polygon with a specified number of sides and is inscribed within a center and radius.
Required Inputs
Center - Specify the center point.
Radius - Specify the inscribed radius.
Sides - Specify the number of sides.
Optional Inputs
Angle - Use this option to rotate the polygon by the specified angle.
Polygon
(2D), Circumscribed Radius Method
The Circumscribed Radius method creates a polygon with a specified number of sides circumscribed about a center point and a specified radius.
Required Inputs
Center - Specify the center point.
Radius - Specify the inscribed radius.
Sides - Specify the number of sides.
Optional Inputs
Angle - Use this option to rotate the polygon by the specified angle.
Polygon
(2D), Side Length Method
The Side Length method creates a polygon with a specified number of sides. One corner is at a specified point and all sides are a specified length.
Required Inputs
Corner - Specify a corner point.
Length - Specify the length of all side.
Sides - Specify the number of sides.
Optional Inputs
Angle - Use this option to rotate the polygon by the specified angle.
Polygon
(2D), Inscribed Boundary Method
The Inscribed Boundary method creates a polygon with a specified number of sides and inscribed about a radius point.
Required Inputs
Center - Specify the center point.
Boundary - Specify the inscribed boundary point.
Sides - Specify the number of sides.
Polygon
(2D), Circumscribed Boundary Method
The Circumscribed Boundary method creates a polygon with a specified number of sides and circumscribed about boundary point.
Required Inputs
Center - Specify the center point.
Boundary - Specify the inscribed boundary point.
Sides - Specify the number of sides.
Polygon
(2D), Side Boundary Method
The Side Boundary method creates a polygon by defining one of its edges and a specified number of sides.
Required Inputs
Center - Specify the center point.
Boundary - Specify the inscribed boundary point.
Sides - Specify the number of sides.
