Curve by Control Points (3D/2D)
Insert
Wireframe Curves (Part Level)
Insert
Geometry Curves (Sketch/Sheet Level)
Use this command to create
a curve by defining a series of control points. The curve will begin and
end at the first and last control points.
The points in between will control the curve's shape. You can use the Optional Inputs (see below) to specify the degree of the curve.
Points - Select a series of points to control the curve. Middle-click to end the curve. The last point selected will be the end point of the curve.
Degree - Refers
to the degree of the equation that defines the curve. Curves of a lesser
degree are less exact and require less storage and computation time. Curves
of a higher degree are more exact and require increased storage
and computation time. The degree must be smaller tan the total number
of control points specified.
Select from degree 2 through degree 6.
