Circle (Radius/Diameter, Center) (3D)

Insert Wireframe Circles (Part Level)

Use this command to create a circle by entering a radius and selecting a center point. You can create circles of the same radius in multiple locations by selecting additional center points.

Required Inputs

1st point

Select a point on the plane of the circle.

2nd point

Select a second point on the plane of the circle.

Center

Each center point selected will define a unique plane that each circle will lie on.

• Select the center point. These three points define the plane that the circle will lie on.

• Select additional center points for multiple circles of the same radius or middle-click to continue.
   

Radius/Diameter

Use this option to indicate the type of input desired for the Rad/Dia option below.  
 

• Radius - The value entered will be the radius.

• Diameter - The value entered will be the diameter.
   

Rad/Dia

Specify the circle radius or diameter depending on the mode selected above.