Arcs Connected Tangentially
Insert
Geometry Line (Sketch/Sheet
Level)
Use this command to create
a chain of tangent arcs attached end-to-end. First select a start point
and the start tangent angle of the first arc. Then select end points where
the arcs are connected.
Select the start point of the first arc.
If you selected the Tangent
input option by right-clicking the mouse during step
1 and then selected a curve, select the tangent direction. Otherwise,
proceed to step 3.
Outward - The direction of tangent is toward the outer side
of the curve.
Inward - The direction of tangent is toward the inner side of
the curve.
Specify the start tangent angle of the first arc or middle-click for zero degrees.
Select end points until the desired arc chain is created.
