Arc (Center, Start, End) (3D)
Insert
Wireframe Arc (Part Level)
Use this command to create a 3D arc by defining
its center, two plane definition points and then the start and end points.
Select the center point.
Select a point on the plane of the new arc.
Select a second point on the
plane of the new arc.
These three points define the plane on which the arc will lie.
Select the start point or enter the Rad/Dia (see below )of the arc.
If you selected a start point, select the end point, enter the swept angle, or select a curve to extend to. If you entered the Rad/Dia of the arc, specify the start angle measured CCW from the axis defined by the center point and the first point on the plane of the new arc.
Rad/Dia
Use this option to indicate the type of input
desired during circle and arc commands.
Radius - The value entered will be the radius.
Diameter - The value entered will be the diameter.
Direction
Use this option to indicate the direction
for angular input. The initial default for this command option is CCW.
CCW - The angle entered will be measured counter clockwise.
CW - The angle entered will be measured clockwise.
