Line (Double) (2D)
Insert
Geometry Line (Sketch/Sheet Level)
Use this command to create a multi segmented
double line attached end-to-end. You can enter the right and left-hand
width of the double lines as measured from an imaginary line between the
points.
Left width - Specify the left-hand width.
Right width - Specify the right-hand width.
Points - Select the end points of each double line segment.
Insert arc
Use this option to insert a full arc at the outside corners of each line segment. The radius of the arcs is determined by the left and right width values.
Closed
Specify that the line segments created are to be open or closed.
Open - The double line has a start point and an end point. The start and the end of the double line are influenced only by the start and end point respectively.
Closed
the double line is continuous. The start and end segments of the double
line are influenced by both start and end points together.
