Inquire Face Continuity Error
Inquire
Face
Use this command to analyze the tangent continuity
across two mating faces at a selected edge. The edge must be shared by
both faces. The results displayed are the maximum and average error measured
in degrees. You can also check for C0 continuity (gaps) along the edge
by selecting Position from the Continuity option.
Edge
Select an edge to analyze.
Scale
Adjust the error display by entering a scale factor or pick Escape.
Continuity
Use this option to specify the continuity level to be checked.
Position - Displays the C0 discontinuity error. If gaps are present, the maximum and average gap distance between the two faces along the selected edge is calculated and displayed.
Tangent - Displays the tangent continuity error as described by the Display Continuity Error command.
Sample
Use this option to specify the number of points to be sampled along a selected edge.
Specify the number of points to be sampled.Enter a number between 20 and 500. The default value is 100 points.
