Print (Ctrl+P)
File
Print
Use this command to send the print data to
the location specified in the Print destination input field of
the Print
Setup Form. All
settings defined by the active print setup configuration will be applied.
Select the print origin. Use the mouse buttons as indicated below to locate and orient the print. If the Print Setup Form is set for Dynamic Printing a view of the current paper size is also displayed.
Left-click to select the dynamic print origin.
Middle-click
to reset the print origin as follows.
At the part level - middle-click to reset to the 0,0,0 origin of the default XY plane as seen from the top view.
At the sketch level - middle-click to reset to the 0,0 origin of the sketch plane.
At the Drawing Sheet Level - middle-click to reset to the lower-left corner of the drawing sheet.
Right-click to display the InputOptions menu shown here. You can change the rotation angle of the current paper size that is displayed.
A change to the rotation angle will be reflected in the Print Setup Form. You can also set the input mode for the left-mouse button (see above) to Grid, Absolute, or Critical.
