Electrode
Table (2D) 
Insert 
Electrode Table (Drawing
Sheet Level)
Use this command to create an electrode table
and place it in the Table Manager. The table is based on a layout view
that contains features created from the Electrode Blank
command in its associated part. First
you select the layout view and then you enter a name for the table.
Optional inputs allow you to control the contents and attributes of the table. Refer to the Optional Inputs section below. Once complete, use the Table Manager to insert the electrode table onto your drawing sheet. Tables can be blanked and unblanked if desired.
This command comes in handy when you have many electrodes of different sizes and locations that makes identification cumbersome. This command creates balloon or note labels attached to each electrode shown in the view. After the command is complete, you can double-click on the labels to relocate them as desired.
Column Editor - The list on the left shows the column headings that will be included in the electrode table. Place a check in the box next to a heading to add it to the list. Use the Delete, Move Up and Move Down buttons to act upon the selected column header in the list.
Balloon/Note - Use this option to specify the format for the hole label. Balloon uses circles and ID numbers to identity the electrode locations. Note only shows the ID numbers similar to a Label Dimension.
Start label - You can specify the starting label number for the first electrode in the table. By default, the next available electrode label number is specified.
Currently, this command will not regenerate if the 3D electrode feature locations change and the view is regenerated. You will have to delete and recreate the electrode table.
