Cross section polygon

Menu access: View | Cross section polygon

Description:

Allows you to quickly create a cutting line on a view without creating the corresponding section at the same time.

General philosophy:

1. Select the reference view.

2. Select the section line to use or click on  CONTOUR  to create it.

3. Then choose between.

•  OK  Confirm the section line.

•  INVERT  Invert the direction of the section line arrows.

•  EXTREMITIES  Allows you to extend or to shorten section line extremities.

Specific point(s):

If the document contains only one view, the selection of the reference view is not required.

Available modification(s):

You can later on modify the cross section polygon using