|
|
|
|---|
|
|
|
|---|
Right lateral faces
Menu access : Sheet metal | Other operations | Right lateral faces
Description :
Allows to right an inclined lateral face.
These face are obtained when you make drilling using inclined coordinate system or when you trim a sheet metal part using an inclined plane. This function allows to obtain the same layout pattern whatever the selected reference face.
General philosophy :
Choose one of the three proposed options.
Select an edge or a sheet metal part.
Available option(s) :
Loop mode :
The selection is validate only when the edge loop join inclined lateral faces. In this mode the AUTOMATIC SELECTION option allows to automatically select all the edges corresponding to this criteria. It's recommended to select edge loops located on each side of the sheet metal part.
|
Before righting |
After righting |
|
|
|
Edge path mode :
This mode is nearly the same than the Loop mode, but it works on boundary edge.
|
Before righting |
After righting |
|
|
|
Linear edge mode :
Righting of an linear edge with or without adding matter (the selected edge determine the righting level).
|
Before righting |
After righting |
|
|
|
|
|
|
