Falling part cutting direction

This parameter defines the falling part cutting direction. Four or two solutions are available

• Four if the falling part cutting is "type finish"

• Two if the falling part cutting is "type serial"

• Disable (of course) if the falling part cutting is "annul or direct"

Normal

The falling part will be in the same direction as the roughing.

That is in the following order: :

Threading at the threading point

Moves in rapid mode until the glue

Stop to clamp the part

Moves in feed rate to cut the glue

or

Stop to clamp the part

Moves in feed rate to cut the glue

Inverted

The falling part will be in the opposite direction as the roughing.

That is in the following order:

Stop at the beginning to clamp the part

Moves in feed rate to cut the glue

or

Threading at the threading point

Moves in feed rate to cut the glue

Normal zigzag

In case of falling part cut with as many as cuts as there are finishing cuts (with the cutting conditions of each finishing!)  , the direction of the various passes will be reversed every time, the first pass will be the same direction as the roughing.

Inverted zigzag

In case of falling part cut with as many as cuts as there are finishing cuts (with the cutting conditions of each finishing!)  , the direction of the various passes will be reversed every time, the first pass will be the opposite direction as the roughing.

Topsolid online Help Index