Falling part cutting

This parameter determines method to use for the cut of falling part (glue) , four solutions are available:

Direct

The falling part (glue) cut is realized just behind the roughing. Example :

Serial

All the falling parts (glues) cut are realized together after all the roughing cuts. Example :

Cancel

In this case, the falling part (glue) cut is NOT done (It will be done for example<later manually). Example :

Finish

In this case, there will be so much  falling part (glue) cuts as finishing cuts (with the same conditions). In this case, the falling part cuts will not be visible on the finish part. Example :

Topsolid online Help Index