First point / second point
The first point P1 defines the starting "altitude" of the eventual draft for the insert.
The second point P2 defines the point where the construction origin of the defining contour of the body of the insert will be created.
You will have to define these points, if you have not done that before defining the direction with the method by point.
The points can be defined by points or faces. In this case use the button TRIM WITH FACE when the system asks..
Before define the second point enter the value for the draft.
Depending of the altitude selection of the P1 and P2 points, you can obtain different results.
|
|
|
|
In cases where no angle draft is applied the definition
of P1 has very little importance but nevertheless you will have to select
it. You can then select any point on the cavity (edge, parting line, etc...).
Topsolid online Help Index
