Topsolid online Help Index

On direct mode

1. Select a entering face The selection click will be the entering point P1 of the circuit.

2. Give the following P2 point. It will be possible to change the level by entering a distance  dZ, or generating a new POSITION.

3. Manage the exit point. You can also enter specific values for the diameter of the circuit, the added length and the ending hole angle.

4. OK the water line.

5. Continue with the circuit:

• By START FROM THE OTHER POINT. By default the circuit will continue from the last picked point. With this option you can select a different following point.

• Selecting a new POSITION.

• Selecting an OFFSET.

• Changing the level by entering a value of dZ.

• Ending the cooling system by clicking on END.

Available options:

An help bar appears during the cooling circuit creation. This window allows you to :

• Section view : Displays section view of the target and the part to inject. The section plane is depending on XY plane of the current coordinate system.

• Show / Hide clash : Allows to to check quickly clashes with the part to inject.

• Show / Hide efficiency : Allows to show efficiency areas of your cooling circuit.

• Show / Hide part

Specific point(s):

Tools of the bar are updated dynamically. You can mix them.

Topsolid online Help Index