No lead in

This parameter allows to keep or remove the lead in points (magenta color) in the DMIS file.

The lead in points ( magenta colour) are created perpendicularly to the  face to measure, on the measured points (blue ones). They are given with the center of the ball touch.

The green points represent the Lead in/out of the operation. They are created perpendicularly to the face to measure, at the intersection with the security block (distance (F)). They are given with the center of the ball touch.

• NO

The lead in points (magenta color) ARE in the DMIS file.

• YES

The lead in points (magenta color) are NOT in the DMIS file. In this case, the lead in/out security distance which is used is the security defined on the controller machine.

be careful to the clash in this case. TopSolid'Control does NOT simulate the same as the machine movements

Topsolid online Help Index