Point 1 : Bottom sensor
Point 2 : Left sensor
Point 3 : Front sensor
Point 4 : Right sensor
Point 5 : Rear sensor
Digit star
A Digit star has five available sensors. TopSolid'Control defines in automatic these five tool offsets.
These sensors are numbered from one to five. This number appears generally in the code DMIS, after the letter P.
Example : T2_A0B0P4
- T2 is the tool number
- A0B0 is the orientation of the tool ( Wcs )
- P4 is the sensor used with the digit star (right sensor).
Definition of the number of the sensors:
|
Point 1 : Bottom sensor Point 2 : Left sensor Point 3 : Front sensor Point 4 : Right sensor Point 5 : Rear sensor
|
|
Topsolid online Help Index