Size feature

This option is available only if the field "Type feature" is set to "Actual".

Four  solutions are then possible:

NONE

No option is used, either RFS, or MMC, or LMC

RFS (Regardless Feature Size)

The tolerance is fixed

The DMIS output is so like  xxx,RFS,xxx

MMC (Maximum Material Condition)(Maximum material principle)

In that case, the tolerance is dynamic, according to the measured dimension. Look at the Maximum material principle  chapter.

The DMIS output is so like xxx,MMC,xxx

LMC (Least Material Condition)(Minimum material principle)

In that case, the tolerance is dynamic, according to the measured dimension. Look at the Minimum material principle chapter.

The DMIS output is so like xxx,LMC,xxx

This parameter is taken into account in the DMIS file ONLY if it's possible to use it in the current control operation

Topsolid online Help Index