|
|
|
|---|
|
|
|
|---|
Topsolid online Help Index
Angularity
Menu: Control | Geometrical | Angularity
Icon: 
Links:
Create an instruction of control of an angularity tolerance.
The instruction will be TOL/ANGLR in the DMIS file.
Definition of the angularity:
The surface to tolerance must be included between two parallel plans distant from the given tolerance, and can be inclined of the given value with regard to the reference element.
It's necessary to select two elements.
This elements can be :
A measurement already done (measurement of a plane,line or cylinder)
A geometrical element (plane,line,cylinder) on which an operation of measure will be in advance created if it's not done yet.
The first element is the element to control, the second one is the referenced element.
Select the menu
"Control | Geometrical | Angularity" or click on icon.
Select the element to control (line, cylinder,plane or measure).
If the element is not a measure,
It's possible to use the existing measure (if the element was already measured) or to make again the measure.
The measure will be done in automatic before the control if no measure was done.
Select the referenced element (line, cylinder,plane or measure).
If the element is not a measure,
It's possible to use the existing measure (if the element was already measured) or to make again the measure.
The measure will be done in automatic before the control if no measure was done.
A dialog box appears. Modify some parameters if necessary and confirm .
Click
the various zones of the image below to have help
Topsolid online Help Index
