|
|
|
|---|
|
|
|
|---|
Topsolid online Help Index
Circularity
Menu: Control | Geometrical | Circularity
Icon: 
Links:
Create an instruction of control of a circularity tolerance.
The instruction will be TOL/CIRLTY in the DMIS file.
Definition of the circularity:
The profile of every section must be included between two concentric circles. The difference of the radius of these two circles is the required tolerance.
The internal circle is the biggest inscribed circle.
It's necessary to select one element.
This element can be :
A measurement already done (measurement of a circle, cylinder)
A geometrical element (circle, cylinder) on which an operation of measure will be in advance created if it's not done yet.
Select the menu
"Control | Geometrical | Circularity" or click on icon
Select the element (circle, cylinder, measure).
If the element is not a measure,
It's possible to use the existing measure (if the element was already measured) or to make again the measure.
The measure will be done in automatic before the control if no measure was done.
A dialog box appears. Modify some parameters if necessary and confirm .
Click the various zones of the image below to have help
Topsolid online Help Index
