|
|
|
|---|
|
|
|
|---|
Topsolid online Help Index
Run-out
Menu: Control | Geometrical | Run-out
Icon: 
Links:
Create an instruction of control of a run-out tolerance.
The instruction will be TOL/CRNOUT in the DMIS file.
Definition of the Run-out :
The run-out tolerance is used for the surfaces of revolution. The radial run-out of the surface during the complete revolutions of the part around the axis of the reference cylinder A, must be included between 2 coaxial cylinders distant from the given tolerance,where the axes must be along the reference axis cylinder A.
It's necessary to select at least two elements, and at most four elements.
This elements can be :
A measurement already done (measurement of a plane or cylinder)
A geometrical element (plane or cylinder) on which an operation of measure will be in advance created if it's not done yet.
The first element is the element to control, the other elements will be the referenced element.
Select the menu
"Control | Geometrical | Run-out" or click on icon.
Select the element to control (plane or cylinder, measure).
If the element is not a measure,
It's possible to use the existing measure (if the element was already measured) or to make again the measure.
The measure will be done in automatic before the control if no measure was done.
Select the first referenced element (plane or cylinder, measure).
If the element is not a measure,
It's possible to use the existing measure (if the element was already measured) or to make again the measure.
The measure will be done in automatic before the control if no measure was done.
Select the second referenced element (plane or cylinder, measure), or click on the Quit button
If the element is not a measure,
It's possible to use the existing measure (if the element was already measured) or to make again the measure.
The measure will be done in automatic before the control if no measure was done.
Select the third referenced element (plane or cylinder, measure), or click on the Quit button
If the element is not a measure,
It's possible to use the existing measure (if the element was already measured) or to make again the measure.
The measure will be done in automatic before the control if no measure was done.
A dialog box appears. Modify some parameters if necessary and confirm .
Click the various zones of the image below to have help
Topsolid online Help Index
