Retract method.

There are four methods possible for the retract between each "depth" allowed

None

In that case, no lead out is done

Incremental

In that case, the lead out is done with an incremental value. This value is defined by the user with the "Retract" question.

The feed rate used for this lead out is defined by the feed rate or the current stage

Until the previous stage

In that case, the lead out is done until a specific value defined by the previous stage

The feed rate used for this lead out is defined by the feed rate or the current stage

Until stock diameter

In that case, the lead out is done until a specific value defined by the starting Z of the parting off

The feed rate used for this lead out is defined by the feed rate or the current stage

Topsolid CAM online Help Index