Minimum pockets width = 0
Minimum pockets width >= 10
Minimum pockets width >= 20
Minimum pockets width >= 30
Minimum pockets width
This parameter is available only if the option " Pocket plunge" is activated.
This parameter allows to not plunge in pockets where the width (width of the pocket - offset) is lower (or equal) to the value given by the user.
Examples:
A = 10 , B = 20 , C = 30, Offset = 0
|
Minimum pockets width = 0 |
|
Minimum pockets width >= 10 |
|
Minimum pockets width >= 20 |
|
Minimum pockets width >= 30 |
Topsolid CAM online Help Index