None
Nothing is done during the roughing cycle.
Total
The tool goes over all the processed area (like a semi finishing pass).
Partial
The tool only goes over the areas where it's necessary (no vertical or no horizontal entities).
Levelling type
The rough cycle leaves crest (scallop), at the end of each cut. Sometimes, it's better to remove this left material during the roughing machining to have a perfect finishing.
Three modes of levelling type are available :
|
|
Nothing is done during the roughing cycle.
The tool goes over all the processed area (like a semi finishing pass).
The tool only goes over the areas where it's necessary (no vertical or no horizontal entities).
|
Topsolid CAM online Help Index