|
|
|
|---|
|
|
|
|---|
Topsolid CAM online Help Index
Levelling method : At end of each pass if necessary
Links:
Purpose
The levelling pass (in red below) takes place at the end of each pass only if the tool do not remove all the material according to the minimum angle field (See samples)
In that case, the tool follows the profile to reach the position of the previous pass.
The check box Levelling from the top to the bottom allows to make the levelling passes with the same direction as the roughing direction (See Samples)
Click the various zones
of the image below to have help
Topsolid CAM online Help Index
