None

It is NOT necessary to fix some any limitations. The machining area is fine.

Window

With this mode, the user can limit the machinable area proposed by TopSolid'Cam, by applying a Z and X limitations.

The window is defined with a rectangle defined by the  two extreme points.

On Z

The user defines a point, where the Z coordinate represents the machining limit.

This  Z limit takes into account the machining direction.

For an external left tool on the rear turret, the Z limitation corresponds to a maximum Z.

On X

The user defines a point, where the X coordinate represents the machining limit.

This  Z limit takes into account the machining direction.

For an external left  tool on the rear turret, the X limitation corresponds to a minimum X.

For an internal left tool on the rear turret, the X limitation corresponds to a maximum X.