Retraction between points
This parameter defines
The starting Z
The final Z
The retract between two points
Three solutions are available:
Retraction between points = Retract to clearance plane
Z1 = Value defined in clearance plane (Absolute value)
Z2 = Retract plane between two points
In this case,
the retract between two points = the starting Z and the final Z
(Z2) = (Z1)
Retraction between points = Do not retract
Z2 = Starting Z of the operation + Security distance of the operation (usually 2mm in the default values)
Retraction between points = Retract of obstacle height
H1 = Obstacle height (Incremental value)
Z2 = Starting z of the operation + H1 + Security distance of the operation (usually 2mm in the default values)
This method is usually used with manuals cycles.
Another optimized solution exists when the finish part and the stock part are defined.
From the operations manager :
Select the button.
In the "Collision" tab, check the parameter "Check collisions at drilling cycle"
In the cycle operation, select the solution Retraction between points = Do not retract
In this case, as the check collision is activated, the Z2 value will be automatically updated according to the maximum height of the part or clamps between two points.
Z2 = Starting z of the operation + Security distance of the operation (usually 2mm in the default values) + Obstacle height (part or clamps) if necessary
Topsolid CAM online Help Index