Use a different Z step on vertical faces

This parameter is ENABLED ONLY if the scallop management is checked.

: In that case, the scallop management is the same for all the faces

: In that case, the scallop management is different for the "vertical" faces (in fact closed to vertical) and the other ones.

For the "vertical" faces, TopSolid'Cam uses the Z STEP value ( big  (A). value in the drawing below)

For the other ones, this step (which is NO more linked to the scallop height) is NOT use. TopSolid'Cam uses the scallop height

: So, of course in that mode, the Z step is NO MORE linked to the scallop height

Example :

Topsolid CAM online Help Index