SPINDL/s[,RPM SFM][,CLW CCLW][,RANGE,n][,MAXRPM,m][,RADIUS,r][,INCR,i][,LINEAR]
Causes an S-code block to be output for spindle condition.
s Is the required units of speed.
RPM States the value of s in revolutions per minute.
SFM States the value of s in surface units per minute.
CLW Generates an M code for clockwise spindle direction.
CCLW Generates an M code for counter clockwise spindle direction.
RANGE,n Selects the spindle range number n.
MAXRPM,m
States the maximum RPM, m, to be used in SFM mode.
RADIUS,r States the initial radius, r, for SFM mode.
INCR,i Gives the step over percentage, i, in SFM mode.
LINEAR Skips speed changes for circular moves in SFM mode.
MAXRPM, RADIUS, and LINEAR are non modal options. Initially RPM,RANGE,1 and CLW are assumed.
The SFM default options are:
MAXRPM The maximum limit in current range.
RADIUS The current Machine X axis position.
INCR 0.0
LINEAR Allow speed changes for circular moves
SPINDL/ON OFF
ON Reinstates the last spindle condition.
OFF Generates an M code to turn off spindle.
SPINDL/LOCK,AUTO ON OFF
For SFM mode, this statement provides speed change control.
AUTO Inhibits speed changes for rapid moves and allows speed changes for feed moves automatically. This is the default condition assumed.
ON Inhibits any speed changes.
OFF Permits speed changes.
SPINDL/s[,RPM SFM][,CLW CCLW][,RANGE,n] [,MAXRPM,m][,RADIUS,r]
Causes an S-code block to be output for spindle condition.
s Is the required units of speed.
RPM States the value of s in revolutions per minute.
SFM States the value of s in surface units per minute.
CLW Generates an M code for clockwise spindle direction.
CCLW Generates an M code for counter clockwise spindle direction.
RANGE,n Selects the spindle range number n.
MAXRPM,m States the maximum RPM, m, to be used in SFM mode.
RADIUS,r States the initial radius, r, for SFM mode.
MAXRPM, RADIUS, and LINEAR are non modal options. Initially RPM,RANGE,1 and CLW are assumed.
The SFM default options are:
MAXRPM The maximum limit in current range.
RADIUS The current Machine X axis position If the machine X axis (.INC and CL Y) is at 0.0 (startup default) and a RADIUS value is not programmed, an R0.0 will be output.
SPINDL/ON OFF
ON Reinstates the last spindle condition.
OFF Generates an M code to turn off spindle.
SPINDL/LOCK,AUTO ON OFF SPINDL/LOCK,AUTO,LAST
For SFM mode, this statement provides speed change control.
AUTO Inhibits speed changes for rapid moves and allows speed changes for feed moves automatically. This is the default condition assumed.
AUTO,LAST Will cause the inhibit/permit M-codes to be output on a block by themselves.
ON Generates an M code to inhibit speed changes.
OFF Generates an M code to permit speed changes.
SPSTCMND.chm