FEDRAT/f[,IPM IPR MMPM MMPR][,RAPTO[,d]]
f Is the feedrate value to be used for subsequent non-rapid motion.
IPM MMPM Specifies units per minute feed.
IPR MMPR Specifies units per revolution feed.
IPM MMPM and IPR MMPR are modal; initially IPM MMPM is assumed.
Note: The mode (inch or metric) is selected in the MACHIN/ statement and no number conversions are done to FEDRAT entries.
RAPTO Is a non modal option which causes the next motion to be split into two blocks. The first block is a rapid move to within a distance d, from the end point. The second block is at the feedrate f for the remaining distance d.
d The value d remains in effect for subsequent RAPTO options until changed. Initially 0.3 is assumed for d.
FEDRAT/LOCK,ON OFF
This command generates the M codes to control feedrate override options.
ON Generates an M code to enable feedrate override.
OFF Generates an M code to disable feedrate override.
SPSTCMND.chm