Cut a single surface by following flow lines that define the surface.

Cut Control Tab

Generate a toolpath by projecting an existing toolpath, created on one part design, onto the surface(s) of another design.

Project Control Tab

Use the side of the tool to cut a surface. The tool shank is oriented parallel to the surface during the cut with the side angle having a value of zero.

Swarf Control Tab

This is a one pass operation that can be used as a swarf operation, a contour operation, or both.

This operation can be used to perform a contour cut on a spline using a guide surface associated with multiple bottom surfaces that control the cut.

Bottom surfaces are gouge protected and avoided.

For more information, see 4 and 5 Axis Contour.

Contour Control Tab

Trim excess material from the edge or periphery of a part.
Trim Control Tab

Used to perform Z axis canned cycles including drilling, reaming, tapping and boring.

See Hole Processing

Used when one (or more) of the axes on the machine is rotary. It changes the output of the toolpath rapid movements to be represented by cylindrical motion rather than linear.

See Set Axis.