Comments Follow
Any of these characters begin a comment on a line. The remainder of the line following the any of these characters is ignored.
Center Of Arcs
Select the method to locate centers of arcs. The center may be in absolute coordinates, relative to the start, or the end of the arc. The default is relative to the start location.
Implied Decimal Places
Check the box if the controller assumes a decimal point after a specified number of digits. Specify the number of digits.
NC File Is For Lathe
Check the box if the NC file is a lathe file.
X-Axis Coordinates
Specify whether the X-Axis is a diameter or a radius value.