Click any field to learn more.
Initial Power Setting
Enter the initial power setting. This value is used by the machine for the initial burn into the material.
Power Setting
Enter the power setting. This value is used by the machine for the length of the contour.
Taper Angle
Specify the angle of the wire as it moves along the contour. See Taper Angle.
Spark Gap
This value defines the distance to offset the tool path for spark compensation. The system does not include this offset in the tool path, rather it is used by the control.
Wire Feed
If the machine has the ability to automatically feed the wire through the material, set this to Yes.
Program Number
Specifies the program number that the NC machine will use for the program being generated. On some controls, this is the O number at the top of the program.