Cut Check Surfaces is active only when Gouge Check is set to Multi Surfaces. When Cut Check Surfaces is checked, the operation cuts over the selected check surfaces. If not checked, the operation retracts to the Rapid Plane, then repositions to the point where the cut continues beyond the check surfaces. The operation then rapids to within the Plunge Clearance and plunges using the Plunge Rate and continues the cut.
Example: Cut Check Surfaces, 3 Axis Cut Operation
In this example, Gouge Check is set to Multi Surfaces. The blue portion is the selected check surfaces. The green surface is the selected cut surface.
|
Cut Check Surfaces ON The tool cuts the check surfaces. |
|
|
Cut Check Surfaces OFF The tool avoids the check surfaces. |
|
|
Cut Check Surfaces ON, with Check Surface Clearance The tool avoids the check surfaces by the Check Surface Clearance value. |
|
|
Isometric View |
|
|
Cut Check Surfaces OFF, with Check Surface Clearance The tool avoids the check surfaces by the Check Surface Clearance value. |
|
|
Isometric view |
|
