On the
SURFCAM main menu, click Tools
> Options. Then
click System >
Input
Device. Then select Digitizer
Tablet.
Be sure that the Digtab digitizing tablet is properly connected to the computer.
Be sure the digitizing tablet driver and Wintab driver have been installed by using the setup program that comes with your digitizer. At this time when you move the pointing tool around the active area, the screen cursor should respond to the movement of the pointing device. If not, please re-install your digitizer software.
If the Digtab application
is not already open, start the application.
Run the file Digtab.exe
from the ../Surfnnnn
folder.
If the settings are configured correctly, the coordinates of current pointing tool will be displayed on the coordinate plane. Otherwise an error message will appear.
