It is not necessary to initialize the simulation in this case because we are restarting from a previous solution. The latter may be inspected by displaying the initial velocity and temperature profiles.
The initial velocity and temperature profiles will be displayed in the Graphics window.
The heat transfer monitor plot created in section Visualizing the Solution of the Heated Fin Tutorial will again be used to monitor the simulation progress.
It is possible to stop the solution part way through the run by clicking on the 
(Stop) button in the toolbar and continue again later by clicking on the 
(Run) button. If left alone, the simulation will continue until a further 2,000 iterations have been completed.
The Residuals plot at the end of the calculation should look as shown below.
The final part of the tutorial involves Visualizing the Results.
