It is not necessary to initialize the simulation because we are restarting from a previous solution. To display Scalar Scene 1:
The initial velocity and temperature profiles will be displayed in the Graphics window.
The heat transfer monitor plot created in the Heated Fin Tutorial's Visualizing the Solution section will again be used to monitor the simulation progress.
If you do not see this button, use the Solution > Run menu item. The Residuals display will be created automatically and will show the progress being made by the solver. If necessary, click on the Residuals tab to bring the Residuals plot into view. The tabs at the top of the Graphics window make it possible to select any one of the active displays for viewing.
It is possible to stop the solution part way through the run by clicking on the 
(Stop) button in the toolbar and continue again later by clicking on the 
(Run) button. If left alone, the simulation will continue until a further 300 iterations have been completed.
The Residuals display at the end of the calculation should look as shown below.
