If it is not already open, click
here 
to open FoodProcessor.slddrw
(or browse to install_dir\samples\tutorial\advdrawings\FoodProcessor.slddrw).
Select the Sheet4 tab at the lower-left corner of the drawing.
You can create an exploded view in a drawing by using an exploded configuration of an assembly.
If it is not already open, click
here to open FoodProcessor.slddrw
(or browse to install_dir\samples\tutorial\advdrawings\FoodProcessor.slddrw).
Select the Sheet4 tab at the lower-left corner of the drawing.
The drawing sheet is empty.
Click Model View
(Drawing toolbar).
In the PropertyManager, click Browse, then open install_dir\samples\tutorial\advdrawings\motor casing.sldasm.
In the PropertyManager, under:
Orientation,
click *Isometric 
.
Scale, select Use custom scale, then select User Defined and set the scale to 1:4.
Click to place the view in the drawing approximately
as shown, then click 
.
