Zoom to the top right corner of Structural Member3.
Click End Cap
(Weldments
toolbar).
In the PropertyManager, click 
.
Under Parameters:
Now add end caps to close the open ends of the segments of the back structural member.
Zoom to the top right corner of Structural Member3.
Click End Cap
(Weldments
toolbar).
In the PropertyManager, click .
Under Parameters:
Select the top face
as shown for Face 
.
Set Thickness
to 3.
Under Offset:
Select Use
thickness ratio, and set Thickness
Ratio 
to 0.5.
Select Chamfer
corners, and set Chamfer
Distance 
to 3.
Click 
.
Repeat steps 4 through 6 to cap the remaining three open profiles on Structural Member3.
Click 
to close the PropertyManager.
In the FeatureManager
design tree, End cap1 through
End cap4 appear and Cut
list 
is incremented.
