1. Move the Position tolerance slider for a finer or coarser tolerance. The default position tolerance is 0.1 mm.

During face comparison, Compare Documents compares the position of vertex coordinates and some surface points of face pairs. Vertices or points that lie within a specified position tolerance are considered identical.

Click Reset Tolerances to reset the Position tolerance to system defaults.

2. Click OK.

1. Move the Angle tolerance slider for a finer or coarser tolerance. The default angle tolerance is  6.0e-8 degrees.

During face comparison, Compare Documents compares the parallelism of the edges of face pairs. If the edges are curved, tangents to the curves are compared. The faces are identical if the angle between their corresponding edges is less than the specified angle tolerance.

Click Reset Tolerances to reset the Angle tolerance to system defaults.

2. Click OK.