In a drawing view, sketch a closed profile such as a circle.
Click Crop View 
on the Drawing toolbar, or click Insert,
Drawing View, Crop.
The view outside the profile disappears.
You can crop any drawing view except a Detail View, a view from which a Detail View has been created, or an exploded view. Crop View can save steps because you do not create a new view. For example, instead of creating a Section View and then a Detail View, then hiding the unnecessary Section View, you can crop the Section View directly.
To crop a view:
In a drawing view, sketch a closed profile such as a circle.
Click Crop View on the Drawing toolbar, or click Insert,
Drawing View, Crop.
The view outside the profile disappears.
|
A circle is drawn on this Section View |
After cropping, only the view inside the circle is displayed. |
|
|
|
To edit a Crop View:
Right-click the drawing view in the graphics area or in the FeatureManager design tree and select Crop View, Edit Crop.
Edit the profile.
Click Rebuild
to update the view.
To remove a Crop View:
Right-click the drawing view in the graphics area or in the FeatureManager design tree and select Crop View, Remove Crop.
The crop is removed and the view returns to its uncropped state.
