Direction
1 and Direction 2 are fully
interchangeable in the PropertyManager. You achieve the same results whether
you select entities using Direction 1
or 2.The boundary surface feature lets you create surfaces that can be tangent or curvature continuous in both directions (all sides of the surface). In most cases, this delivers a higher quality result than the loft tool. Consumer product designers and others who require high quality surfaces with curvature continuity can use this tool.
Direction
1 and Direction 2 are fully
interchangeable in the PropertyManager. You achieve the same results whether
you select entities using Direction 1
or 2.
|
|
|
|
Single curve to a point in one direction |
Three curves in directions 1and 2 |
To create a boundary surface feature:
Click Boundary
Surface 
(Surface toolbar) or Insert,
Surface, Boundary
Surface.
Set the PropertyManager options.
Curve callouts colors match those used in the PropertyManager.
Click callouts to change the Tangent Type.
Click 
.
