Sketch a line on the face of a sheet metal part where you want to create the jog. Alternatively, you can select the Jog feature before you create a sketch (but after you select a plane). When you select the Jog feature, a sketch opens on the plane.
Click Jog
on the Sheet Metal toolbar, or click Insert,
Sheet Metal, Jog.
In the graphics area, select a face for Fixed Face
.Under Selections, to edit the bend radius, clear Use default radius, and type a new value for Bend Radius
.
Under Jog Offset:
Select an item in End Condition.
Set a value for Offset Distance
.Select a Dimension position: Outside Offset
, Inside Offset
, or Overall Dimension
.Select Fix projected length if you want the face of the jog to stay the same length.
Under Jog Position, select: Bend Centerline
, Material Inside
, Material Outside 
, or Bend Outside 
.Set a value for Jog Angle
.To use something other than the default bend allowance, select Custom Bend Allowance, and set a bend allowance type and value.
Click OK
.
