Apply dimensions and relations calculated by the SolidWorks application to fully define sketches or selected sketch entities.
All entities in sketch. Fully defines the sketch by applying combinations of relations and dimensions.
Selected entities. Applies relations and dimensions only to specific sketch entities that you select for Entities to Fully Define.
Calculate. Analyzes the sketch and generates the appropriate relations and dimensions.
Select Relations to Apply
Select All. Includes all relations in the results.
Deselect All. Omits all relations in the results.
Individual relations. Include or exclude those relations from the results. For example:
|
|
Include horizontal relations |
|
|
Exclude horizontal relations |
In some sketches only certain
relations and dimensions can fully define the sketch. Limiting your selection
may prevent the sketch
from being fully defined.
Horizontal Dimensions Scheme and Vertical Dimensions Scheme
Baseline dimensions
Ordinate dimensions
Chain dimensions
Datum
for Horizontal
and Vertical
dimensions.
Dimension placement. Inserts the dimensions:
Above sketch or Below sketch
Right of sketch or Left of sketch
|
|
|
|
Baseline dimensions |
Ordinate dimensions |
