Line Properties PropertyManager - 2D

Controls the following properties of a sketched 2D Line.

Existing Relations

• Relations . Displays relations inferenced automatically during sketching or created manually with Add Relations. When you select a relation in the list, a callout is highlighted in the graphics area.

• Information . Displays the status of the selected sketch entity (Fully Defined, Under Defined, and so on).

Add Relations

You can add relations to the selected entity. The list includes only relations that are possible for the selected entity.

Options

For construction. Converts the entity to construction geometry.

Infinite length. Creates a line of infinite length that you can later trim.

Parameters

You can specify any appropriate combination of the following parameters (or Additional Parameters) to define the line if the line is not constrained by relations. When you change one or more parameters, the other parameters update automatically.

	Length
	Angle. Relative to the grid, with horizontal 180°, vertical 90°, and the positive direction counterclockwise.

Additional Parameters

	Start X Coordinate
	Start Y Coordinate
	End X Coordinate
	End Y Coordinate
	Delta X. Difference between the start and end X coordinates.
	Delta Y. Difference between the start and end Y coordinates.

Return SolidWorks Help Index